Difference between revisions of "SamsungTV"

From HSYCO
Jump to navigation Jump to search
(Created page with "The Samsung Smart TV driver for HSYCO allows you to control most recent Smart TV models from HSYCO web interfaces and application logic. The driver can send most of the remo...")
 
Line 30: Line 30:
 
You can easily associate any user button to a specific command to be sent to the TV. Set ''name'' to the I/O Server name and ''param'' to the command code.
 
You can easily associate any user button to a specific command to be sent to the TV. Set ''name'' to the I/O Server name and ''param'' to the command code.
  
[[File:IO Server SamsungTV Interface.png|center]]
+
[[File:IO Server SamsungTV Interface.png|thumb]]
  
 
You can also enable the Repeat mode, so that multiple commands will be sent to the TV while the button is pressed.
 
You can also enable the Repeat mode, so that multiple commands will be sent to the TV while the button is pressed.

Revision as of 16:03, 19 March 2014

The Samsung Smart TV driver for HSYCO allows you to control most recent Smart TV models from HSYCO web interfaces and application logic.

The driver can send most of the remote control commands, and a few extra commands not present on the remote, but can’t turn on a TV. The driver is basically one-way, it sends commands but doesn’t have any information of the current state of the TV, it only knows if the TV is on and can accept commands from HSYCO.

When you initially configure the Smart TV I/O server in HSYCO and the server restarts, you should have your TV on. The TV will then show a message asking to accept connections from HSYCO.

We can’t provide a list of Samsung Smart TV models that work with this driver. In general, most recent models from 2012 on should work. We do not guarantee that this driver will work with any specific model and firmware version.

Datapoints

ID Value R/W Description
send <command code> W send control command


User Interface

You can easily associate any user button to a specific command to be sent to the TV. Set name to the I/O Server name and param to the command code.

IO Server SamsungTV Interface.png

You can also enable the Repeat mode, so that multiple commands will be sent to the TV while the button is pressed.

See the list of available commands in the table below.

Smart TV Control

Most Samsung Smart TV models should accept the following commands. Other undocumented commands may also be supported.

Command code Description
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
UP up
DOWN down
LEFT left
RIGHT right
ENTER enter
INFO info
EXIT exit
RETURN return
MENU menu
TOOLS tools
SOURCE source
VOLUP increase volume
VOLDOWN decrease volume
MUTE mute
CHUP next channel
CHDOWN previous channel
TV select the internal TV tuner source
HDMI select one of the HDMI sources (depends on the TV model)
POWEROFF turn TV off (can’t turn it back on)
PIP_ONOFF picture-in-picture on/off
PIP_CHDOWN next channel in PIP window
PIP_CHUP previous channel in PIP window
PIP_SWAP swaps PIP and main screen sources

Release Notes

3.3.0

  • initial release version


Samsung and Samsung Smart TV are either trademarks or registered trademarks of Samsung Electronics Co., Ltd.