Difference between revisions of "HwgMonitor"

From HSYCO
Jump to navigation Jump to search
Line 30: Line 30:
  
 
All HWg monitoring devices allow you to assign custom names to each sensor connected to a device.
 
All HWg monitoring devices allow you to assign custom names to each sensor connected to a device.
 
 
The name is important, as it is used by HSYCO as the id to retrieve the sensor’s data.
 
The name is important, as it is used by HSYCO as the id to retrieve the sensor’s data.
 
 
You should configure these names, using the configuration interface of the device.
 
You should configure these names, using the configuration interface of the device.
  

Revision as of 16:12, 24 March 2014

The HWGMONITOR I/O Server supports the following monitoring devices from HW group:

  • Damocles
  • Poseidon
  • STE
  • WLD.

HSYCO Configuration

Add an HWGMONITOR I/O Server in the I/O Servers section of the Settings and set its parameters:

Communication

  • IP Address: host name or IP address of the device
  • IP Port: TCP/IP port to use, leave blank to use default port 80.

High Availability

  • Shutdown when inactive: defaults to true (these devices accept multiple connection and could be accessed by two HSYCO servers simultaneously).

Options

There are no available configuration options for the HWGMONITOR I/O Server.

Monitoring Devices Configuration

This I/O Server uses the XML format and HTTP requests to constantly poll the devices for the current status.

All HWg monitoring devices allow you to assign custom names to each sensor connected to a device. The name is important, as it is used by HSYCO as the id to retrieve the sensor’s data. You should configure these names, using the configuration interface of the device.

Refer to the device manual for detailed configuration information.

Datapoints

The data points associated to the input pins are named “i1” to “i8”.

The data points associated to the output pins are named “o1” to “o8”.

The I/O Server generates asynchronous events based on the status of the I/O Controller's input and output pins. The output data points can be written to control the output pins.

ID Value R/W Description
i<n> 0 R input <n> is low
1 R input <n> is high
o<n> 0 R output <n> is low
W set output <n> to off
1 R output <n> is high
W set output N to on

Release Notes

3.0.1

  • Fixed a bug that could block the update of the systemtopo.txt file at start-up.

2.8.4

  • Support for the HWg Damocles line of products, with input lines counters.

2.8.0

  • Initial support.


HWg is a registered trademark of HW group s.r.o.