Cradlepoint

From HSYCO
Revision as of 16:32, 13 September 2014 by Ulde (talk | contribs) (→‎Options)
Jump to navigation Jump to search

The Cradlepoint driver for HSYCO allows you to monitor the real-time status of the Cradlepoint IBR6xx series of routers.

IO Servers Cradlepoint.png

HSYCO Configuration

Add a CRADLEPOINT I/O Server in the I/O Servers section of the Settings and set its parameters:

Communication

  • IP Address: LAN IP address of the IBR6xx router
  • IP Port: TCP/IP port to use for the SSH CLI (Command Line Interface), leave blank to use default port 22.

High Availability

  • Shutdown when inactive: defaults to false.

Options

ID Default Values Description
startupevents false true generate IO events also during the driver’s start-up phase
false start generating events only after HSYCO is aligned with the current status of the system
query /status/wan/connection_state /status/system/wan_signal_strength /status/wan/stats space-separated pathnames this parameter can be used to retrieve specific status data from the router. Use / to retrieve all data (note that using / the router will need several seconds to return all data, and the number of generated data points will be huge. You should specify the / full path only for development purposes

Datapoints

ID Value R/W Description
send <command_code> W send the specified control command (see table below)

Most Samsung Smart TV models should accept the following command codes. Other undocumented commands may also be supported.

Command code Description
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
UP up
DOWN down
LEFT left
RIGHT right
ENTER enter
INFO info
EXIT exit
RETURN return
MENU menu
TOOLS tools
SOURCE source
VOLUP increase volume
VOLDOWN decrease volume
MUTE mute
CHUP next channel
CHDOWN previous channel
TV select the internal TV tuner source
HDMI select one of the HDMI sources (depends on the TV model)
POWEROFF turn TV off (can’t turn it back on)
PIP_ONOFF picture-in-picture on/off
PIP_CHDOWN next channel in PIP window
PIP_CHUP previous channel in PIP window
PIP_SWAP swaps PIP and main screen sources

User Interface

You can easily associate any user button to a specific command to be sent to the TV. Set name to the I/O Server name and param to the command code.

IO Server SamsungTV Interface.png

You can also enable the Repeat mode, so that multiple commands will be sent to the TV while the button is pressed.

Release Notes

3.3.0

  • initial release version


Samsung and Samsung Smart TV are either trademarks or registered trademarks of Samsung Electronics Co., Ltd.