Galaxy

The Honeywell Galaxy Dimension panels are multi-area intrusion detection systems. The integration with HSYCO can be accomplished via RS-232 serial communication.

Communication

Employ a RS-232 straight cable to connect the panel directly to HSYCO or to an Ethernet/RS-232 gateway.

RS-232 parameters:

Baud rate	9600
Data bits	8
Stop bit	1
Parity	none
Flow control	none

Configuration

It is required to configure the panel for HSYCO to be able to communicate with it. Follow these instructions:

• Enable the engineer access

  Menu 48.1.1 - set to 1 (Enabled)

• Enable engineer mode

  Enter engineer PIN, followed by ENT

• Enable remote access and events reporting

  Menu 56.6.2 - set to 1 (SIA)

  Set SIA level to 4

  Enable (set to ON) all the events to be sent to HSYCO

  Menu 56.6.3 - set an account number (e.g. “0001”)

Options

ID	Default	Values	Description
gui	true	true	enable automatic support of UI objects to show the system status and intercept control buttons
		false	disable support for the UI
startupevents	false	true	generate IO events also during the driver’s start-up phase
		false	start generating events only after HSYCO is aligned with the current status of the system
offlinelogs	true	false	at startup request the log of all the events occurred while HSYCO was disconnected from the panel
		false	log only events occurred while HSYCO was connected to the panel
pollinterval	1	n > 0	the data acquisition interval, in seconds
logsize	20	n ≥ 0	the number of log lines to display in the UI object