Avigilon

From HSYCO
Jump to navigation Jump to search

Avigilon Control Center (ACC) 7 is a video management software that can be integrated in HSYCO with a TCP/IP connection. The current release of the I/O Server has been tested with the Avigilon Control Center 7.6.0.22

Note This driver supports only a single connection with an Avigilon Control Server. If you have multiple Avigilon Control Servers it is mandatory to add more I/O servers to HSYCO, one for each Avigilon Control Server. Every I/O server must use a different TCP/IP port.

Communication

Here's an example of how to configure Avigilon Control Center to get a message from HSYCO and trigger an action.

Select POS Trasanction in the Advanced configuration menu

IO Server Avigilon 2.png

Set the transaction source device to the IP address of HSYCO and TCP/IP port specified in the I/O Server declaration (e.g. 10001)

IO Server Avigilon 3.png

Edit the Transaction Source Data Format

IO Server Avigilon 4.png

Configure data format as follows

IO Server Avigilon 5.png

In this example HSYCO is using the following format:

#
dummyalarm.z24.open=0
*

Where "dummyalarm.z24.open" is a datapoint, "0" its value

Now it is possible to setup Transaction Exceptions, for example to trigger a recording when a zone is alarmed.

IO Server Avigilon 6.png
IO Server Avigilon 7.png
IO Server Avigilon 8.png
IO Server Avigilon 9.png

HSYCO Configuration

Add an AVIGILON I/O Server in the I/O Servers section of the Settings and set its parameters:

Communication

  • IP Address: IP address of the AVIGILON ACC 7 server. Set to 0.0.0.0 to allow any remote IP address to connect.
  • IP Port: TCP/IP port to use, leave blank to use default port 10001

High Availability

  • Shutdown when inactive: defaults to false.


Release Notes

3.7.0

  • initial release


AVIGILON is a registered trademark of Avigilon Corporation