Hidedgesolo

The HID Edge Solo ESR40, ESRP40, ES400 are single-door IP access control solutions.

This I/O Server allows the integration of HID Edge Solo devices by using a TCP/IP connection.

More than one device can be controlled at the same time.

HID Edge Solo Configuration

The HID Edge Solo can be connected to a POE switch or to a normal ethernet switch. In this case the power supply must be provided with an external adapter. First of all, assign a static IP address to the Edge Solo, then it’s mandatory to disable the SSL/TLS encryption in the installer settings interface.

HSYCO Configuration

Add an HIDEDGESOLO I/O Server in the I/O Servers section of the Settings and set its parameters:

Communication

• IP Address: IP address configured on the device
• IP Port: TCP/IP port to use, leave blank for default port 80.

Authentication

• User: username set in the installer settings
• Password: password set in the installer settings.

High Availability

• Shutdown when inactive: defaults to true.

Datapoints

If two readers are connected to the Edge Solo controller, the reader specific data points have a 0. or 1. prefix to identify each reader.

ID	Value	R/W	Description
connection	online	R	connection established
	offline	R	HSYCO can't connect to the panel
card.notfound	<code>	R	badge <code> not found
pin.notfound	<pin>	R	<pin> not found
access.granted	<surname>	R	access granted to the user with surname <surname>
access.granted.extended	<surname>	R	access granted extended to the user with surname <surname>
access.denied.schedule	<surname>	R	access denied because badge/pin of the user <surname> was used outside scheduled time interval
access.denied.expired	<surname>	R	access denied because badge/pin of the user <surname> is expired
card.notassigned	<code>	R	access denied because the badge <code> is not assigned to an user.
access.denied.pin.expired	<surname>	R	access denied because the pin assigned to the user <surname> is expired
alarm.acknowledged	0	R	alarms reset
	1	R	normal conditions
door.lock.schedule	false	R	normal conditions
	true	R	door locked with a scheduled command
door.unlock.schedule	false	R	normal conditions
	true	R	door unlocked with a scheduled command
alarm.door.forced	unset	R	normal conditions
	set	R	door forced alarm
alarm.tamper	unset	R	normal conditions
	set	R	tamper alarm
access.granted.manual	false	R	normal conditions
	true	R	manual access granted
door.unlock	false	R	normal conditions
	true	R	door unlocked
state.alarm.tamper	unset	R	normal conditions
	set	R	tamper alarm
state.alarm.ac	unset	R	normal conditions
	set	R	power supply failure
state.alarm.battery	unset	R	normal conditions
	set	R	battery failure
state.alarm.door.held	unset	R	normal conditions
	set	R	door held
state.alarm.door.forced	unset	R	normal conditions
	set	R	door forced
state.name	<name>	R	the door's name
state.relay	unset	R	door relay closed
	set	R	door relay open
state.relay.alert	unset	R	alert relay not active
	set	R	alert relay active
state.relay.aux	unset	R	aux relay not active
	set	R	aux relay active
command.access	grant	W	grant the access
command.door	lock	W	lock the door
	unlock	W	unlock the door
command.alarm	stop	W	alarms reset

Release Notes

3.6.0

• added support for firmware version 2.0

3.4.0

• added support for two readers door controller

3.0.0

• initial release

---

HID is a registered trademark of HID Global.