Difference between revisions of "NETIO"
Jump to navigation
Jump to search
| Line 4: | Line 4: | ||
== Device Configuration == | == Device Configuration == | ||
| − | Firstly device must be configured with it's web configuration page (see device manual instruction for this step). | + | Firstly the device must be configured with it's web configuration page (see device manual instruction for this step). At the first startup the device acts as an access point, connect to it and configure your network credentials, '''remember to assign a static IP address to the device''' (remove the flag from DHCP option) as shown below: |
[[File:NETIO_ip_configuration.png|border|600px|center|Network configuration]] | [[File:NETIO_ip_configuration.png|border|600px|center|Network configuration]] | ||
Revision as of 17:46, 19 November 2020
This driver commands NETIO devices and reads status from them, it uses HTTP protocol with basic authentication.
Device Configuration
Firstly the device must be configured with it's web configuration page (see device manual instruction for this step). At the first startup the device acts as an access point, connect to it and configure your network credentials, remember to assign a static IP address to the device (remove the flag from DHCP option) as shown below:
HSYCO Configuration
Add the NETIO I/O Server in the I/O Servers section of the Settings and set its parameters:
Communication
- IP Address: local IP address of NETIO device
Authentication
- User: username, as set with NETIO web configuration page
- Password: password, as set with NETIO web configuration page
