Difference between revisions of "NETIO"
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
Firstly the device must be configured with it's web configuration page. | Firstly the device must be configured with it's web configuration page. | ||
| − | At the first startup the device acts as an access point, connect to it (see device manual for this step) and configure your network credentials | + | At the first startup the device acts as an access point, connect to it (see device manual for this step) and configure your network credentials. '''Remember to assign a static IP address to the device''' (remove the flag from DHCP option) as shown in the example below: |
[[File:NETIO_ip_configuration.png|border|600px|center|Network configuration]] | [[File:NETIO_ip_configuration.png|border|600px|center|Network configuration]] | ||
Revision as of 17:51, 19 November 2020
This driver commands a NETIO power socket and reads status from it, it uses HTTP protocol with basic authentication (username and password).
Device Configuration
Firstly the device must be configured with it's web configuration page.
At the first startup the device acts as an access point, connect to it (see device manual for this step) and configure your network credentials. Remember to assign a static IP address to the device (remove the flag from DHCP option) as shown in the example below:
HSYCO Configuration
Add the NETIO I/O Server in the I/O Servers section of the Settings and set its parameters:
Communication
- IP Address: local IP address of NETIO device
Authentication
- User: username, as set with NETIO web configuration page
- Password: password, as set with NETIO web configuration page
