NETIO

This driver commands NETIO devices and reads status from them, it uses HTTP protocol with basic authentication.

Device Configuration

Firstly the device must be configured with it's web configuration page.

At the first startup the device acts as an access point, connect to it (see device manual for this step) and configure your network credentials, remember to assign a static IP address to the device (remove the flag from DHCP option) as shown below:

Network configuration

HSYCO Configuration

Add the NETIO I/O Server in the I/O Servers section of the Settings and set its parameters:

Communication

• IP Address: local IP address of NETIO device

Authentication

• User: username, as set with NETIO web configuration page
• Password: password, as set with NETIO web configuration page