Axis Cameras

How to configure Axis cameras with Hsyco

From a Web browser, typer the URL to access the Axis camera interface. (for example http://192.168.1.180).

Basic Setup > TCP/IP: To change the camera IP address go to the basic TCP/IP Settings section:

Basic Setup > Users > Add: add the user “hsyco” setting User Name and Password as Settings (Camera.axis.User = hsyco Camera.axis.Password = 00000000)

User Name: “hsyco” Password: “00000000”

Motion and PIR detection configuration with old firmware (before 2011)

Events > Event Servers > Add HTTP: add a new HTTP Server and specify: Name: Hsyco, for example URL: http://192.168.0.50/x/camerarec (192.168.0.50 is the HSYCO IP address)

Events > Event Types > Add Triggered: event triggered by a PIR sensor

Send HTTP notification to the HSYCO server and specify the camera id, as defined in Settings

• Send HTTP notification to “Hsyco”
• Custom parameters: camera=axis

The following screenshot shows an example of an event triggered by motion detection. First of all, you need to add the window of motion (Events > Motion Detection)

Events > Event Types > Add Triggered: define the event triggered by motion detection

Send HTTP notification to the HSYCO server and specify the camera id, as defined in the hsyco.ini file

• Send HTTP notification to “Hsyco”
• Custom parameters: camera=axis

Motion and PIR detection configuration with new firmware (after 2011)

Detectors > Motion Detection. Add window.

Events > Recipients and click “Add...”. Set as follows:

• Type:HTTP
• URL: http://HSYCOIPADDRESS/x/camerarec

Events > Action Rules and click “Add...”

Events > Action Rule > Add > Action Rule Setup: event triggered by motion detection

In this example the name of camera is“axisp3364”, as defined in Settings