Difference between revisions of "Elsner"
Jump to navigation
Jump to search
Line 93: | Line 93: | ||
|signed integer<br/> -40C .. +80C | |signed integer<br/> -40C .. +80C | ||
|R | |R | ||
− | |signed integer representing the measured temperature, in 10th of Celsius degrees (e.g. 210 corresponds to 21.0C) | + | |signed integer representing the measured temperature, in 10th of Celsius degrees<br/> (e.g. 210 corresponds to 21.0C) |
|- | |- | ||
Revision as of 15:48, 10 March 2014
The Elsner P03/3-MODBUS is a solid-state weather station with a standard Modbus RTU slave interface. It measures temperature, wind speed and brightness (eastern, southern and western sun) and recognizes precipitation.
Contents
Communication
The P03/3 has a Modbus interface. The default connection parameters are:
- Modbus address: 1
- RS-232 parameters:
Baud rate | 19200 |
Data bits | 8 |
Stop bit | 1 |
Parity | even |
Flow control | none |
Refer to the P03/3 data sheet for installation, wiring and power supply requirements.
HSYCO Configuration
Options
ID | Default | Values | Description |
---|---|---|---|
gui | true | true | enable support for the UI object, UISET actions and USER commands |
false | disable UI support | ||
startupevents | false | true | generate IO events also during the driver’s start-up phase |
false | start generating events only after HSYCO is aligned with the current status of the system | ||
pollinterval | 30 | > 1 | the data acquisition interval, in seconds |
address | 1 | > 1 | the Modbus address of the P03/3 device |
Datapoints
ID | Value | R/W | Description | |||
---|---|---|---|---|---|---|
connection | online | R | connection established to the P03/3 | |||
R | offline | HSYCO can’t connect to the P03/3 | ||||
temp | signed integer -40C .. +80C |
R | signed integer representing the measured temperature, in 10th of Celsius degrees (e.g. 210 corresponds to 21.0C) | |||
light | positive integer 0 .. 99 |
R | ambient light in kilolux, equal to the maximum value detected by the three side sensors | |||
light.east | positive integer 0 .. 99 |
R | ambient light in kilolux, detected from East-side sensor | |||
light.south | positive integer 0 .. 99 |
R | ambient light in kilolux, detected from South-side sensor | |||
light.west | positive integer 0 .. 99 |
R | ambient light in kilolux, detected from West-side sensor | |||
wind | positive integer | R | wind in 10th of m/s (e.g. 32 corresponds to 3.2 m/s) | |||
rain | 0 | R | no rain | 1 | R | rain |
User Interface
UISET Actions
ID | Attribute | Set to | |
---|---|---|---|
temp | value | the current temperature in Celsius degrees with one decimal digit, followed by " °C" | |
light | value | the current ambient light in Klux, followed by " Klux" | |
wind | value | the current wind in m/s, followed by " m/s" |
Release Notes
2.10
- full integration in HSYCO 2.10.0
Elsner is a registered trademark of Elsner Elektronik GmbH.